1. Door Viewer
We got a 190 degree door viewer, 160 would also work well. We bought this at a local Home Depot for about $10 but it can be purchased at just about any hardware store. The higher the degree number the wider Angle of view.
2. Lens Cap
For our DIY fisheye lens we are using a Nikon D700 with a 24-70mm lens. So we went to a camera store and bought a knock off lens cap for about $8. The only important thing is that it fits your camera. We don’t want to use the actual lens cap, you’ll see why in just a moment. You could also use an old rear lens cap if it’s the right Size.
Any will work. Just make sure your bit is large enough to drill a hole that the peephole will fit through snugly.
4. Duct Tape
Just in case the knock off lens cap doesn’t fit 100% properly.
5. DSLR Camera
Putting Everything Together
Make sure your drill bit is about the same diameter Size as the peephole and drill a hole into the center of the cap. Our hole was slightly too small to fit the peephole through, so we were able to use scissors to carve it out a little more until it was the right fit.
Next unscrew the door viewer and then attach the two parts again with the lens cap. Clear off any extra plastic and make sure the peephole is centered and won’t move around, glue it in place if necessary.
Attach your cap to the camera, but be cautious with the viewing end of the peephole to make sure it won’t scratch your lens.
Set your camera to manual focus and you’re ready to shoot!
It’s as simple as that.
We had fun walking around the city and shooting with our DIY fisheye lens. Check out some photos we shot with our lens and if you decide to make your own be sure to share them with Phlearn! We would love to see them!
Text-align: center;”>[nggallery id=104]